1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 312Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 312

12311241 30Install the two retainers, washers, and screwsApply OMC Ultra Lock-271 to threads of the two retainer screwsInstall
water and check for source of leakageMake necessary repairs and repeat test Screw in vacuum testerPump out to 3-5 in(76-127
mm) of mercury and see if vacuum holdsThen, pump out to 15 in(381 mm) of mercury and checkIf the gearcase fails to hold on
either test, put oil around suspected sealIf leak then stops or oil is drawn in, that seal is defectiveWhen the gearcase
checks OK, refill with the proper lubricant 32Fill the gearcase with lubricant as follows: Secure the gearcase in an upright
position Remove the oil level plug and the drainfill plug Replace their seals, if damaged Fill the gearcase with OMC Ultra-HPFgearcase
lube until it appears at the oil level holeInstall the oil level plug, then the drainfill plugTighten them to 84-86 inIbs(9-10