1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 314Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 314

Installation 1Place new O-ring on the driveshaftCoat the driveshaft splines with OMC Moly LubeDo not coat top surface of
the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of position 4Apply
OMC Gasket Sealing Compound to the attaching screwsInstall and tighten the screws as follows: GEARCASE RETAINING SCREWS inretaining
screws inretaining screws 26-28 ftIbs(35-38 Nm) 45-50 ftIbs(61-68 Nm) 5If removed, install the trim tab and gasket and align
trim tab with the index marksTighten the screw to 35-40 ftIbs(47-54 Nm) & 6Engage the shift rod in the shift rod link and