1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 318Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 318

f6l f718Pull up on the driveshaft to remove it from the gearcase The driveshaft to pinion taper is locking taperIf necessary,
needle bearings that may have fallen into the gearcase 11Push down on the shift rodThis will move the detent lever downward
to clear the inside of the gearcase when the propeller shaft assembly is pulled outr,Ql12Completely unscrew the shift rod,
but do not pull it out of the shift rod coverRemove the six cover screws, then lift off the shift rod and cover assemblyDiscard
the gasket underneath r;v f12l13Reach into the shift cavity with suitable tool and depress the detent leverWhile holding
the detent lever down, pull the clutch shaft and bearing housing assembly out of the gearcaseIf the detent lever is not held
in the fully depressed position, it will pop up when the clutch shaft is pulled and prevent removal of the clutch shaft and