1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 320Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 320

23Remove the pinion bearing only if it needs to be replacedBefore attempting removal: V6Remove bearing retaining ring from
bearing up and out of the gearcase Make sure all loose needles are inside bearing case before pulling bearingThe needles
will provide surface for the remover tool to pull against25If water intake screen cannot be unplugged by cleaning, replace
it 1251 vaRemove screw on starboard side of gearcase above screenPlace screwdriver on each side of the intake screen under
the locating tabsSimultaneously, press in and up on both sides to free screenTo install new screens, place port side in first,
wide end downPush down and to side until screen bottoms in cavityPlace starboard side in and press down until screen snaps