1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 323Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 323

21 Push the propeller shaft out of the bearing housing22Remove thrust bearing and thrust washer 23Remove the seal using OMC
were not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring groove and sand off any
sharp edges that would cut O-ring and prevent its sealing 26To replace the front bearing, lightly coat the outside case with
gearcase oilFace the lettered end of the bearing case toward the large diameter end of OMC Bearing Installer, PI 432401,
and slide it onto toolPress bearing into housing until the tool seats27To replace the rear bearing, lightly coat the outside
case with gearcase oilPlace lettered end of bearing case on small diameter end of bearing installer, then press bearing into