1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 324Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 324

!1ID 28Install new seal in rear of the bearing housing using OMC Seal Installer, PIN 341439Apply oil to casing of the seal
housing 22 32Coat bearing surfaces of propeller shaft with gearcase oilSlide the propeller housing on the propeller shaft
NoteUse caution when assembling the propeller shaft in the bearing housing Thrust bearing must remain around shoulder on
the propeller shaft 33Lightly oil the threads of the forward gear assemblyCarefully start the threads in the housing and
screw it in by hand as far as possibleTighten the gear assembly to 100 ftIbs(136 Nm) using OMC Spanner Wrench, PIN 432400