1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 325Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 325

Driveshaft Bearing Housing Service The driveshaft bearing housing is not serviceableReplace the bearing housing if the bearing
back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease to the seal lips after installing5Lightly
apply OMC Triple-Guard grease to new a-ringInstall the O-ring in top groove of the bearing housing Do not install the a-ring
in the bearing housing's bottom grooveThe bottom groove is an oil passageGearcase damage could result Driveshaft Servicing
[] 1To separate the upper driveshaft from the lower driveshaft, remove the roll pinReplace the damaged component rn theTo
assemble theupper driveshaftthe driveshaft retainer 2driveshaft, install into groove of the38360 3Install the upper driveshaft