1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 326Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 326

0.125 in(3,2 mm) Driveshaft Shimming Using Tool, PIN 393185 0.062 in(1,6 mm) The driveshaft pinion is precisely meshed with
bearing housingthrust washerthrust bearingand pinion onto the driveshaftUse OMC Driveshaft Seal Protector, PIN 318674, whenever
installing or removing the bearing housingLightly coat the threads of the pinion nut with outboard lubricantTighten the pinion
nut as follows : Pinion Nut Torque 70-80 ftIbs(95-108 Nm) 100-110 ftIbs(136-149 Nm) PCE0047 2Select the correct gauge and
collar: V6OMC Gauge, PIN 328367, and OMC Collar, PIN 341440 V8OMC Gauge, PIN 330224, and OMC Collar, PIN 341440 3Slide the
collar onto the driveshaft with large end in contact with the bearing housing 4Insert the assembled driveshaft into the tool
base and tighten preload screw against the driveshaft until groove CD on the spring-loaded plunger is flush with end of threadsTighten