1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 327Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 327

5Rotate the driveshaft several revolutions to seat bearings f13l6 Lay the tool base on its sidePosition the correct shim
if variance exceeds 0.002 in (0,050 mml 9Subtract the average clearance measurement you obtained in Step from 0.020 in(0,508
mm) (VS), 0.030 in(0,762 mm) (Va), to determine the correct shim thickness requiredSelect the fewest number of shims to achieve
the correct thickness10Remove the driveshaft from the tool baseRemove the collar and bearing housing from the driveshaft,
and add the required amount of shimsUse extreme care when removing bearing housing to avoid damaging the sealsUse OMC Driveshaft
Sea Protector, PIN 31867411 Check shimming by reassembling the driveshaft with shims and placing it back into the tool baseThe
measurement between the gauge bar and the pinion should be 0.020 in(0,508 mm) (VS), 0.030 in (0,762 mm) (Va)12Remove the