1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 328Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 328

1Assemble as shown from OMC Universal Pinion Bearing Remover and Installer, PIN 391257: -20 V2 inHex Head Screw in0.0Flat
of the bearingThe bearing is tapered so when installed correctly, its shape compensates for stresses in the gearcase and
allows full bearing contactWhenever you disassemble gearcase, check the pinion bearingit must be in place with the lettering
facing up3Insert the tool with the bearing into the gearcaseDrive the bearing into the gearcase until the washer on the tool
contacts the spacerRemove the toolUsing rag, remove any excess grease from surface of the needle bearings4Install pinion
bearing retainer: V6Seat pinion bearing retaining ring in groove on top of the bearing Position new a-ring on the pinion
bearing retaining screwApply OMC Nut Lock to screw threads and a-ringInstall the screw and tighten to torque of 48-80 inIbs(5-9