1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 352Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 352

r-o o o38287 [] 4Remove pinion and base [[] INote Before disassembly, scribe marks on frame and end caps for reference during
the windings 4Check permanent magnetsMagnets should attract steel or iron objects held inside the frameWeak magnets will
cause excessive RPM on No Load Current Draw, Electric Starter test5Do not clean drive assembly while the starter and drive
are installedThe cleaning agent could drain into the starter, washing dirt from the drive into the bearings and commutatorAfter
disassembling, clean each part with grease solvent and inspect6If the pinion does not properly engage the flywheel, the pinion
and screw shaft assembly may be worn, distorted, or dirtyLocate the cause and correct before completing assemblyAssembly
1Lubricate the armature shaft bearing surface with one drop of SAE No10 oilLubricate pinion helix on armature shaft with