1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 358Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 358

Assembly If removed, apply OMC Locquic Primer and OMC Screw Lock to the brush card screws before installing30364 f.i5112o
the mark next to the positive terminal stud on the gear housing Push the armature down firmly and slide the frame into placeAlign
the notches in the gear housing and frame 1 235Install insulator cap on end of shaft6Apply light coating of OMC Extreme Pressure
Grease to the end cap bearing, and install the end cap 1 247Install the two thru-boltsTighten to torque of 50-65 inIbs(5,6-7,3
Nm)258Lightly coat the drive gear with OMC Triple -Guard grease, and install it on the armature shaftInstall the retaining