1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 370Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 370

r:;::;l9With the engine not running and the key switch in the "ON" position, connect voltmeter to engine wiring harness gray
Removal Note Disconnect battery cables at battery before proceeding 141Remove the power pack2Swing the electrical component
bracket away from the powerhead to expose the rectifierregulator3Remove rectifierregulator red lead from starter solenoid4Loosen
and remove the six retaining screws and the rectifier regulatorInstallation 1Coat both sides of new gasket with OMC Gasket
Sealing Compound and install gasket and new rectifierregulator2Coat the threaded portion of the six retaining screws with
OMC Gasket Sealing Compound and install themThe two front center screws have star washersTighten them to torque of 36-84
inIbs(4-9 Nm)3Attach the rectifierregulator red lead to the battery side of the starter solenoid4Install the electrical component