1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 383Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 383

Pump and Reservoir Servicing Function Tests 1Remove the rear plug from the side of the reservoirOMC Pressure Gauge Install
should be 850-1000 PSI (5861-6895 kPa)6Test the system's flow rate while the boat's steering system is disconnectedWith the
engine running at 700 RPM, cycle the cylinder from fully retracted to fully extended position by pushing on the spool valve
bellcrankCycle time should not exceed 1.5 seconds7When installing the boat's steering system, replace the locknut if you
do not feel definite resistance to tightening The engine's power steering system can react quickly to i and remove all spark
plug leadsequivalent, and F16 insocket 1'- To avoid accidental starting of engine while servicing, twist r,v 1Remove flywheel