1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 387Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 387

Inspection inspecting components, thoroughly clean them with mile aerosol solvent, and blow dry with shop air of not more
hand Check the relief valve seats, balls, and guides for nicks or distortionAssembly The seal and a-rings necessary to assemble
the pump and reservoir are available in OMC a-ring Kit, PI 985330a-rings are identified by dimensions in this assembly procedure
(I.Dx thickness in inches) 13411If removed, install 1341 r:::::l The V4 a new lower shaft bearingPlace the lettered end of
bearing against OMC Installing Tool, PIN 912101, and press into place in(6,3 mm) spacer must be used with all CC (1988) and
newer enginesCU (1987) and older models do not require this spacer when using OMC Installer, PIN 912101 13512Support the
bearing cone and press pump shaft into the upper bearing until bearing seats completely on shoulder 13613Use No.4 external