1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 388Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 388

3714Use plastic mallet to tap the shaft and bearing assembly into the reservoir until upper bearing seats on reservoir shoulder385Use
a-rings (.795 .104" and 2.350 .140") with GM Dexron "fluid, and install in pump housing groovesr;;l 8Match the alignment
bushings and install the gerotor and pump housingInstall the four retaining screws and torque to 120-144 inIbs(14-16 Nm),
following an "X" patternr:;:;J 9Lightly coat the lips of new shaft seal with OMC Triple-Guard greaseLightly coat the seal
0.0with OMC Gasket Sealing CompoundPress into place until completely seated in reservoir r:;:;l10Using new a-rings lubricated