1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 390Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 390

Installation 48 1Place two ramp lock washers, with ramps together, on each of the three pump mounting screws 2Install the
at 500-1000 RPM for 30 seconds 6Recheck reservoir fluid level and fill as necessary52 7Torque the dipstick to 50-60 inIbs(6-7
Nm l 8Route the drive belt around the pump and idler pulleys9Clean the crankshaft and flywheel tapers with OMC Cleaning Solvent
and let air dry153 10Align the flywheel keyway and install flywheelCoat the threads of new retaining nut with OMC Gasket
Sealing CompoundInstall the nut and torque it to 140-150 ftIbs(190-204 Nml1541 11 Install the six pulley screws and torque
to 60-84 inIbs(7-9 Nml12Adjust drive belt tensionRefer to Belt Tension Procedure, this section13Recheck reservoir fluid level