1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 391Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 391

Belt Tension Procedure 1Be sure drive belt is in good condition and correctly routedBelt must engage all pulley grooves 1Il2Idler
and flywheel pulleysBelt tension is correct when the plunger is flush with the end of the handle 5Start engine and run it
at 800 RPM for two minutesStop engine and repeat Steps and 4 r;] 4Verify belt tension using OMC Gauge, PI 984850, midway