1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 394Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 394

Disassembly f"N=J The seals and a-rings required to service the spool valve and cylinder are available in OMC a-Ring Kit,
replacement a-ring f11l1Remove and discard two internal a-rings in the cylinder tilt tube borer:J2l2Remove the valve housing
assemblyIt may be necessary to secure the steering cylinder and tap the valve housing with rubber malletr:J3l3Use OMC Spanner
Wrench, PIN 912084, to remove the cylinder end cap 14 14Remove and discard the end cap a-ring5Inspect the seal inside the
end capReplace backup ring and seal if worn or damaged 1151 6Remove the rod and piston from the cylinder7Inspect the cylinder