1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 396Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 396

1 Spool Valve Shimming rr:J=J This procedure must be performed if the spool valve, housing, or seals have been replacedThis
locknut and washers from the spool valveSave the washers Isl'sl 6Install one O-ring PIN 912357 (0.734 0.139 in on the new
spool valveLubricate both parts with OMC Power TrimlTilt and Power Steering Fluid or Dexron "flu idInsert the spool valve
in the side of the valve body where it was removed Isl 7Push in on the clevis end of the spool valve with about five pounds
of forceMeasure the distance between the valve flange and the valve body with caliperWrite down and label this measurement
as dimension 8Remove the spool valve and insert it in the opposite side of L!l the valve body 9Push in on the clevis end