1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 398Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 398

Assembly 1Lightly coat the piston and O-ring with OMC Power TrimlTilt and Power Steering Fluid or Dexron IIInstall the piston
adaptersteering cylinder Tighten screws to 60-84 in2V8Place the steering cylinder in the engine swivel bracket and slide
the tilt tube into place 3V8Install the starboard locknutReplace the locknut if you do not feel definite resistance to tighteningTorque
the locknuts to 50-54 ftIbs(68-73 Nm) and then loosen one locknut '8 to 14 turn 4Position the steering connector inside the
spool valve housingTurn the engine to extend the connector past the end of the housing5Position the bellcrank under the steering