1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 401Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 401

Installation 1Install the idler assembly on the reservoirInstall the pivot screws and washersas shownInstall, but do not
Nm)6Route drive belt around all pulleysBe sure belt engages all pulley grooves correctly7Set adjustment rod for belt tension
of 25-30 poundsr:;] 8Verify belt tension using OMC Gauge, PIN 984850, midway between the idler and flywheel pulleysBelt tension
is correct when the plunger is flush with the end of the handle 9Start engine and run it at 800 RPM for two minutesStop engine