1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 425Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 425

7(continued) If no voltage at V3, disconnect bluewhite tilt limit switch bullet connectors and re-connect to by-pass tilt
red wire is OK, check black wire between relay socket and engine ground If voltage at V5, go to Step 14 rv (greenwhite).voltmeter
black lead to 14Connect a clean engine ground, and voltmeter red lead to V7 OJ 15Push control box DOWN trim button If no
voltage at V7, check control box trim switch and wiring If voltage at V7go to Step 16 [!] 16Push lower motor cover DOWN trim
button If no voltage at V7, check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck for
voltage at redwhite connector that supplies lower motor cover switch If voltage at V7, go to Step 1717Reinstall DOWN relayPush
blades only halfway into DOWN (green) relay socket 18Push DOWN trim button and check for voltage at If no voltage at va,
go to Relay Ohmmeter Test If voltage at va, go to Step 19 va on relay blade (M terminal of relay) 19Disconnect trim motor's
blue and green power wire connector (leave relay in socket)20Push DOWN trim buttonCheck for voltage on green wire If no voltage,