1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 427Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 427

7(continued) 200225 ModelsIf no voltage at V3, disconnect bluewhite tilt limit switch bullet connectors and re-connect to
bracketIf red wire is OK, check black wire between relay bracket and engine ground If voltage at V5, go to Step 14 rv (greenwhite)voltmeter
black 14Connect lead to clean engine ground, and voltmeter red lead to V7 GJ 15Push control box DOWN trim button If no voltage
at V7, check control box trim switch and wiring, and go to Step 16 If voltage at V7, go to Step 16 [!] 16Push lower motor
cover DOWN trim button If no voltage at V7, check for voltage at greenwhite bullet connector out of lower motor cover trim
switchCheck for voltage at redwhite connector that supplies lower motor cover switch If voltage at V7, go to Step 1717Reinstall
DOWN relayPush blades only halfway into bracket in DOWN (green) end of bracket 18Push DOWN trim button and check for voltage
at V8 on relay blade (M terminal of relay) If no voltage at V8, go to Relay Ohmmeter Test If voltage at V8, go to Step 19