1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 432Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 432

Pressure Leakdown Test LJ verification r:;l OMC Power Trimrrilt Service Kit, PIN 434524, allows external of trimltilt operation
motor to full trim-in stall positionTrim rods will not retract without the gearcase pushing them3Loosen the manual release
valve one turn ill vent I:A 4Jog the trim motor UP, then DOWN, then UP again to any pressure at the manual release valve
before removing itTo avoid personal injury, always wear eye protection when servicing the hydraulic unitSince there might
be significant residual pressure behind some components, cover each component with shop cloth as you remove it5Slowly, remove
the manual release valveHandle the valve very carefullyDo not scratch, bend, or dent the split ringsf41 6Clean and inspect
the manual release valve and its port in the manifoldSplit rings on the valve are not available separatelyIf split rings