1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 433Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 433

f517.lnstall pressure gauge and adapter "A" to check problems in the UP circuitTighten gauge and adapter lightly to 5-10
Steps and 8, install pressure gauge and adapter "8" to check problems in the DOWN circuit12Starting with the tilt cylinder
fully extended, run the unit DOWN The gauge should show 0-200 PSI (0-1379 kPa) as the tilt cylinder is retracting The gauge
should show (5516 kPa) as the unit stallsapproximately 800 PSI Release the switch and watch for pressure dropThe stall pressure
reading must not drop by more than 200 PSI (1379 kPa) after the motor stops13If your test results vary from those in Step
12, problem in the DOWN circuit is indicatedRefer to Hydraulics Troubleshooting, this section i then UP again to vent any
high pressure before removing the gauge '" 14After tests are complete, jog the unit UP, then DOWN, 15Install the manual release