1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 437Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 437

Disassembly Jog the trim motor UP, then DOWN, then UP again to vent any pressure at the manual release valve before removing
paint it after it is completely assembledPainting of individual components may cause flakes of paint to enter the hydraulic
passages during assemblyTape the trim and tilt piston rods before painting 1Screw the manual release valve inRemove the retaining
ring using retaining ring pliersRemove the manual release valve 2Inspect O-ring and two plastic split rings on the manual
release valve for nicks and cutsInspect tip of valve for damageThe two plastic spit rings are not available separatelyIf
rings are damaged, replace the manual release valve rn rn 3.Inspect the reservoir the capdrain the fluid into Remove cap