1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 446Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 446

Trim Sending Unit Adjustment 1Tilt the engine and engage the mooring bracket 2Temporarily, install PIN 387278 thrust rod
engine up and adjust the sending unit by pivoting it up or down6Lower the engine against the thrust rod to verify adjustmentRepeat
Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the
thrust rod ill limiter rod must be installed and in the same location as it was when the motor was brought in for serviceLeaving