1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 450Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 450

Trim-OUTITilt-UP Mode rJl When operating the hydraulic unit in the trim-outtilt-up mode, hydraulic fluid is routed in the
valve and back to the pumpIt is important to note that all fluid on the return path returns to the pumpBecause the trim and
tilt rods displace fluid at the top of the cylinders, the fluid returning to the pump through the reverse lock check is not
sufficient to supply the pump, so additional fluid is drawn from the reservoir5When both the trim and tilt rods are fully
extended and the pressure exceeds 1500 psi (10500 kPa), the trim-up relief valve will open, directing the fluid to the reservoir6When
the hydraulic unit is trimming outtilting up, or when the engine is running in forward gear, the following components must