1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 459Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 459

tJ the UP circuit f21 8Install pressure gauge and adapter "A" to check problem in rr:J=l Tighten gauge and adapter lightly
of possible faults tJ adapter liB" to check problems in the DOWN circuit f21 12Following Steps through 9, install pressure
gauge and 13With all cylinders completely extended, begin running the unit DOWN The gauge should show approximately 800 PSI
(5516 kPa) as the cylinders are retracting The gauge should show approximately 900 PSI (6206 kPa) as the unit stalls The
stall pressure reading must not drop by more than 200 PSI (1379 kPa) after the motor stops14If your test results vary from
those in Step 13, problem in the DOWN circuit is indicatedRefer to Page 9-47 for list of possible faults rv and After tests