1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 462Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 462

Power TriTilt Servicing Removal 1V4Mark angle adjusting rod location and remove rod2Lift engine manually and engage tilt
in shallow tray to catch the hydraulic oil as it drains from the unitNeutralize the internal pressures of the power trimtilt
unit before disassemblingUsing battery, operate the unit until the trim and tilt cylinders are completely downReverse the
connections on the battery and momentarily operate the unit There may be high pressure behind some check valves and hydraulic
linesTo prevent possible eye injury, when removing lines and check valves, be sure to keep clean, "Iint free" shop cloth
covering them until the pressure is releasedUse eye protectionDo not apply heat to the trim manifold or cylindersExces- ill
sive temperature can cause high pressure leaks or failure of partsAlways use "Iintfree" shop cloth when handling power trim
and tilt componentsIf painting the unit is required, paint the unit after it is completely assembledPainting of individual