1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 464Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 464

128Using either OMC Tilt Cylinder End Cap Remover, PIN 326485, or OMC Universal Spanner Wrench, PIN 912084, and breaker
and the four valve assemblies which consist of springplungerand check ball Three of the four springs are one length, and
the fourth spring is another lengthUpon reassembly, these springs can be put in any positionInspect the outer O-ring from
the piston and the O-ring that was around the rodReplace the O-rings if necessaryReassemble the piston by placing one ball,
one plunger, and one spring in each of the four holes in the pistonPlace the outside O-ring on the pistoncUsing sharp screwdriver,
pry the scraper out of the end capDiscard the scraperdPry the O-ring out of the end cap using flat toolOnce the scraper and