1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 473Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 473

2Oil both trim caps and install on the trim rods, as shown3Reinstall the manifold in the holding fixtureOil both trim piston
when you are finished1sl 6Oil both trim end caps and install in the manifoldThread them in flush with the manifold by handUsing
OMC Trim Cylinder End Cap Remover, PIN 324958, and torque wrench, tighten the end caps to torque of 55-60 ftIbs(75-81 Nm)
r7J 7Install the two identical short check valves in the front of the manifoldTighten the valves to torque of 50-60 inIbs(5,5-7,0
Nm) using drag link socket and torque wrench1sl 8Install the longer trimtilt separation valve in the port lower side of the
manifoldTighten the valve to torque of 50-60 inIbs(5,5-7,0 Nm) Oil the pump control piston and install in the position shownInstall
spring on each end of the piston and make sure both springs stay in position correctly when inserting the valve in the manifoldr,Ql