1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 476Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 476

1251 1261 27Thread the end cap into the cylinderUsing torque wrench installed 90 to the special tool, tighten the end cap
the manifold as shownInstall the tilt cylinder pin or thrust rod 128129Rotate the unit into its normal operating position
Using the correct fluid, fill the oil reservoir up to the fill plugInstall and tighten the fill plugDo not torque the fill
plug at this time30Run the motor, then recheck the oil levelCycle the unit several times and check the oil level when the
trim and tilt cylinders are fully extendedA minimum of five complete cycles (adding oil as needed) is required to purge any
air from the system Total oil capacity is 25 floz(740 mI)Install the fill plug and tighten to torque of 45-50 inIbs(5,0-5,5