1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 477Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 477

Installation 29 1Lubricate the tilt cylinder with OMC Triple-Guard greaseSupport the power trim unit in position and insert
of 18-20 ftIbs(24-27 Nm) 5V4Install the angle adjusting rod in same location as removed32 '" 6V6, V8Install the thrust rodsTighten
the nuts on the two thrust rods to torque of 30-35 ftIbs(41-47 Nm) i (68-73 Nm), then back off one nut 14 turn 7Tighten the
tilt tube nuts to torque of 50-54 ftIbs Motor Servicing If performance problem is indicated in Motor Test, No Load or Troubleshooting-Ammeter