1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 487Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 487

If electrical parts are replaced or even removed from the motor, check the following: Wire and high voltage lead routing
tighten firmlyThey keep clamps in position and ends of wires from sparking where lockwashers are called foruse them Spark
plug boots not torn or cracked fully pushed onto spark plug Spark plugs avoid rough handling that could crack ceramic part
of plug(Sparks may jump across outside of plug In transom areaAll connections clean tight (prevents sparks) Electrical cable
not rubbing on sharp objects enough slack to allow full turning without pull loads on cable (prevents sparks) Secure in approved