1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 27Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 27

Break-In Procedure During the first 10 hours of break-in operation you must use 50:1 fueloil ratio in your fuel tank in addition
pump indicatorNext 50 Minutes DO NOT operate engine above half throttle (no more than 2700 RPM) DO NOT hold constant throttle
settingChange engine speed every 15 minutes INote With easy planing boats, use full throttle to quickly accelerate boat onto
planeImmediately reduce throttle to one-half as soon as boat is on planeBE SURE boat remains on plane at this throttle setting
Second Hour _ Use full throttle to accelerate boat onto plane, then reduce throttle setting to three-quartersBE SURE boat
remains on plane at this throttle setting At intervals, apply full throttle for periods of one to two minutes, returning
to three-quarters throttle for cooling period Change engine speed every 15 minutes INote Verify water pump operation by looking
for steady stream of water at the water pump indicatorNext Eight Hours _ Avoid continuous full-throttle operation for extended