1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 30Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 30

Warning System A warning horn is built into the ONIC prewired remote control or is part of the ONIC accessory wiring harnessThis
components function correctly, the horn or wiring may be damagedRepair or replace as requiredRefer to Temperature Switch
TestSection 4Test No Oil Horn []] 1Disconnect the 3-pin Amphenol connector from the oil tank sending unit2Using jumper wire,
connect the tanyellow lead to the black lead in the engine harness connector3With the key switch in the ON position, the
horn should soundIf the horn does not sound, but other electrical components function correctly, the horn or wiring may be
damaged Repair or replace as requiredTest Low Oil Light m sending unitthe 3-pin Amphenol connector from the oil 1Disconnect
tank 2Using jumper wire, connect the tanblack lead to the black lead in the engine harness connector3Pull the manual starter
rope or turn the key switch to the ON position The light at the front of the engine should illuminateRepair or replace the