1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 35Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 35

Submerged Engines Engine Dropped Overboard (Not Running) If engine is recovered from water immediately, it must be serviced
horizontal position (spark plug openings down) and work out all of the water by slowly rotating flywheel approximately 20
times or until there are no signs of water5Drain carburetorsplace engine in upright position and remove carburetors for disassembly
and draining6Starters, electrical connectors, and all electrical equipment should be completely disassembled, cleaned, flushed
with fresh water, treated with water displacing electrical spray, and thoroughly dried before assembly7Inject outboard lubricant
into spark plug holes8Reassemble parts you removed and disconnectedRefill the oil tank with fresh outboard lubricantStart
engine (follow starting instructions) and run 112 hour using the "break-in" fueloil mixtureRun the engine on "break-in" fueloil
mixture for approximately three hours after servicingSee Break-in Procedure in this section9If engine fails to start, remove