1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 37Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 37

1 DRC6043 Synchronization and Linkage Adjustments INote You must perform this step-by-step procedure exactly as written to
342225, to remove and install the ball socket4Tiller Models Only: Remove the pivot screw securing the throttle cable bracket
to the support 5Tiller Models Only: Turn the idle speed adjustment knob counterclockwise to the full SLOW positionVerify
that the knob and the throttle twist grip are in the full SLOW positionVerify that the throttle arm is touching the idle
stop screw 6Tiller Models Only: Rotate the throttle cable bracket to align it with the mounting screw holeRotate the bracket
one revolution toward the cable end to preload the cableInstall the bracket and pivot screw, placing the flat washer between
the bracket and the cable support arm7Remote Models Only: Disconnect the throttle cable from the engine Mirageeng Safety