1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 40Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 40

4Stop the engineTo adjust, use CMC Ball Socket Remover, PIN 342226, to remove the linkage from the spark advance leverAdjust
ATDC6Reconnect the temperature switch connectorCam Follower Pickup rn 1.greasesure theto make arm is against the stop screwinline
Make throttle Use sharp pencil mark on the crankcase, with the ATDC mark on the timer base gridW 2Advance the throttle to
line the mark on the crankcase with the zero mark on the timer base gridUse 564 inball-hex driver to adjust the cam follower
screw so it just touches the cam 3Close the throttle, then open the throttle until the mark lines up with the zero on the
timing gridVerify that the cam follower is just touching the camMaximum Spark Advance 1Advance the throttle to wide-open