1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 44Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 44

Rigging Information Remote Controls To prevent accidental starting of engine, verify that battery cables are disconnected
cable and lubricate with ONIC Triple-Guard grease2Verify that the fast idle lever is down in the RUN position 3Move the remote
control handle to NEUTRAL & Before connecting shift cable, verify control handle position and neutral lockout index plate
orientation 4Move the remote control handle to full throttle in FORWARD rn 5Rotate the propeller shaft and shift the gearcase
into FORWARD6Remove the rubber grommet at the front of the lower motor coverRemove the anchor pocket cover and screwApply
liberal amount ofONlC Triple-Guard grease to both anchor block pockets 7Install the shift cable on the shift lever pinInstall
the retaining clip supplied with the engine 8Pull firmly on cable casing to remove backlash and adjust cable trunnion nut