1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 45Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 45

11Temporarily remove the shift cable from the shift lever pin and verify that the gearcase is in its NEUTRAL detentI Note
wear of shift system components and high shifting effort 4Move engine throttle lever tightly against idle stop screw5Attach
cable casing guide to throttle lever pin using retaining clip supplied with engine [] 6Remove anchor pocket cover and screw
being careful not to disturb the shift cable Pull firmly on throttle cable to remove backlash and install trunnion nut in
anchor pocket[] 7Install the anchor pocket cover and torque screw to 60-84 inIbs(7-9 Nm)8Check cable adjustment; if throttle
cable adjustment is too loose, idle speed might be high and inconsistentIf throttle cable adjustment is too tight, control
effort might be high through the shifting range & 9Inspect installation to ensure that the control cables are attached to
the proper engine levers by lifting the fast idle lever to the START positionIf correctly attached, the throttle cable and
engine throttle lever will move INotel When installing remote control that is not manufactured by Outboard Marine Corporation,