1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 97Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 97

Flywheel Servicing INote In order to produce the voltage necessary to run an ignition system, the flywheel magnets must be
three PIN 309492 screws from OMC Universal Puller Set, PIN 378103, or other suitable tool to hold the flywheelNotel Use care
when threading screws into the flywheelThe screws can be threaded too far into the flywheel and can damage components mounted
on the insideThread the screws carefully into the flywheel until resistance is feltThere should be enough thread engagement
to loosen the flywheel nut or pull the flywheel4Apply CIVIC Moly Lube to threads of pressing screw and center hole of crankshaft5Assemble
the following components from OMC Universal Puller Set, PIN 378103: Body, PIN 307636 Pressing Screw, PIN 307637 Handle, PIN
307638 Screws, PIN 309492 Washers, PIN 307639 6Install the puller on flywheel with body flat side upSeat the shoulder screws