1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 106Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 106

7Position the statorApply CWIC Locquic Primer and CWIC Nut Lock to threads of screws and torque to 84-106 inIbs(9-12 Nm)8Connect
it by applying isopropyl alcohol to both ends of the cavity[] 2Select the proper removal tool for the terminal : CWIC Pin
Remover, PI 322698 CWIC Socket Remover, PIN 322699 3Place the plug or receptacle against the edge of flat surface and allow
clearance for the terminal to be removed 4Insert the removal tool into the terminal and push the terminal from the connector[]
5Pin and socket terminals may be replaced if damaged Crimp new terminals onto the wire at point []] 6Use OMC Crimping Pliers,