1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 110Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 110

Function TestsS.L.OWThis ignition system incorporates the SLDWwarning system, which gradually limits engine speed to approximately
switch tanblue lead2Install correct test propellerStart engine in test tank and run at 3500 RPM 3Attach engine harness tan
lead to clean engine ground If engine slows to approximately 2500 RPM, test temperature switchRefer to Temperature Switch
Test, Section If engine does not slow to approximately 2500 RPM, check wiring or replace ignition module No Oil Sender 1Install
correct test propellerStart engine in test tank and run at 3500 RPM 2Using jumper wire, connect the tanyellow lead to the
black lead in the 3-pin Amphenol connector After four seconds, if engine slows to approximately 2500 RPM, check oil level
in the oil tank After four seconds, if engine does not slow to approximately 2500 RPM, check wiring or replace ignition module3-20