1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 112Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 112

Output Tests cranking output tests must be performed with spark plugs installed and torqued in the cylinder headIf necessary
ground!Note! To prevent high voltage arc, route tester leads at least in(51 mm) from any metal surface3If equipped, install
the clip onto the emergency stop switchCrank the engineSpark should jump each tester gap in sequence4Refer to Troubleshooting
Sequence Chart, Page 3-21Start with your specific fault symptom and continue troubleshooting in sequence!Note! It is possible
for the ignition system to have problem but still produce good outputIf the engine "pops" or "backfires" during starting,