1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 115Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 115

3 DReS017 Ohmmeter TestStop Button Notel All ohmmeter tests must be performed with the engine NOT running rn 1The steering
the clip and lanyard 3Calibrate an ohmmeter on appropriate scaleConnect meter leads between stop button end of connector
and clean engine ground The meter must show high reading4Momentarily, press inward on the stop button The meter must show
low reading5Remove the clip and lanyard The meter must show low reading & To avoid sudden loss of control, replace the stop
button assembly if your test results vary6Complete all ci rcuits disconnected during this test M irageeng Safety Related