1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 117Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 117

STEPPOWER COIL TEST Ground Test 1Disconnect 4-pin Packard connector between stator and ignition module2Set peak-reading voltmeter
and observe meter: If meter shows 100 volts or higher, go to STEPCHARGE COil TEST If meter shows less than 100 volts, check
condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test All ohmmeter
tests must be performed with engine NOT running 1Calibrate ohmmeter on appropriate scale LConnect meter between the two orange
stator leadsMeter must show: Rope Start Electric Start 84 Ohms 57 Ohms 3To test for grounded condition, connect ohmmeter
black lead to clean engine groundAlternately connect ohmmeter red lead between the two orange stator leads: Any needle movement