1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 118Get this manual

1995 Johnson/Evinrude Outboards 25, 35 3-Cylinder Service Manual, Page 118

STEPCHARGE COIL TEST Ground Test 1Disconnect 4-pin Packard connector between stator and ignition module2Set peak-reading
shows 300 volts or higher, go to STEPIGNITION MODULE TEST If meter shows less than 300 volts, check condition of wiring and
connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test 3Crank engine and observe meter: INote
All ohmmeter tests must be performed with engine NOT running 1Calibrate ohmmeter on appropriate scale2Connect meter between
the two brown stator leadsMeter must showRope Start Electric Start 1120 110 Ohms 800 80 Ohms 3To test for grounded condition,
connect ohmmeter black lead to clean engine groundAlternately connect ohmmeter red lead between the two brown stator leads: